Diagnosis
You have attempted to carry out changes in a planning area. However,the system could not find the InfoCube which is assigned to theplanning area.

Procedure
Check the definition of the planning area. Possible causes could be:

• The InfoCube it is based on was deleted. In this case you can no longer
use the planning area. You should delete the area and if necessary,form a new InfoCube.

• The InfoCube it is based on does not have the status 'active'


• The InfoCube it is based on was renamed in SAP BW, after it was
assigned the planning area.

• If the InfoCube is in another system: The RFC destination, through
which a connection was formed to the remote system, was changed,renamed or deleted.

• If the InfoCube is in another system: The connection to the remote
system can not be established due to hardware problems.
If you cannot ascertain the problem it is based on, then notify yoursystem administrator.