Diagnosis
During the conversion of SEM-BCS default values, default values forcharacteristic &V2& were found in client &V1&. However, thischaracteristic is not used in anyconsolidation area as asubassignment.

System Response
The default values are not converted for the characteristic.

Procedure

• This situation can occur, for example, if you have used the
characteristic in a consolidation area as a default value and you havethen deleted this consolidation area. The default values remain in thedatabase but are no longer used by the system.
In this case you can ignore the message.

• If you use characteristic &V2& as a subassignment or create a new
consolidation area later that uses the characteristic as a subassignmentand you want to use that default values that you have already maintained
, proceed as follows:
Make the necessary changes to the consolidation areas.
Regenerate the relevant data bases.
Start the XPRA again.