Diagnosis
The current program must make new entries in Table &v1& . The databasetable check has found that data already exists in the QM objects numberrange.
The data is located in tables JSTO, JEST, ONR00 and it fulfills theselection criterion OBJNR = 'QL*'.
Only data from the QM area should be located in this area.
One of the following reasons may be responsible for data being locatedin the QM objects number range:

• an earlier program run was aborted and some of the data was already
generated

• customer data is located in the above referenced area.

The data may cause database errors to occur during this program run orduring the subsequent operation of the QM module.

Procedure
The corrective action depends on the cause of the error:


• if an earlier program run was aborted and only QM data is
located in the above referenced area, no further action is necessary.

• if customer data is located in this area, clear the incorrect data as
follows:
Check the environment.
If necessary, restore the backup data for tables JSTO, JEST, ONR00 andQALS.
Remove the customer data before you execute the program.