Diagnosis
The process instruction &V2& for phase &V1& of the process order is aprocess data request. In this process instruction, a messagecharacteristic is set up for value assignment using the variable &V3&.However, for one of the following reasons, no value can be determinedfor the variable:

• The variable is not defined in the PI sheet.


• The variable refers to a value or a formula result which has not yet
been recorded or calculated in the PI sheet.

System Response
The data for the process instruction has been reported without themessage characteristic.

Procedure
RESET N1
In the process order, determine the value to which the variable &V3&refers.
If the value is missing in the PI sheet, record or calculated it.
In the case of PI sheets with test function:
Check and, if necessary, correct the definition and the use of thevariables in the process order.
Then create a new control recipe and maintain the corresponding PIsheet.
Change process order
In the case of productive PI sheets:
Errors in the process instruction cannot be corrected for the currentPI sheet.
In the message monitor, check whether the process messsage requested inthe process instruction was sent after you started the function forreporting data.
Call up message monitor
If the message has not yet been sent, manually add the missing value inthe monitor.
If the message has been sent but the characteristic &V3& is needed bycertain destinations, you need to manually post the value in thesedestinations.
INCLUDE 'NA_PLNREZ_HINW' OBJECT DOKU ID TX LANGUAGE E
Change master recipe