Diagnosis
When the SI start date of wage type &V2& is postponed in client &V1&,the SI start date to be postponed cannot be uniquely identified. The SIstart date is the date as of which the Swiss wage type entries (fieldMOLGA = '02') in table T512W must contain coding to enable the new SIto be used. If this report runs during an upgrade, the postponement ismade to 01.01.2002 for customers who implemented the new SI in Release3.1I before the upgrade. If this report is started manually usingreport RPU40AC0, the postponement is made to the start date ofsubapplication SV01 in table T596D. To determine the original SI startdate to be postponed to &V3&, the system searches for entries of thiswage type with an end date later than 01.01.1998 but earlier than01.01.2002. If more than one entry meets this criterion, the systemcannot uniquely identify the records which must be changed.

System Response
The wage type is not converted. This can cause errors in Swiss Payroll(reports RPCALCC0 and RPCALCCM) and in evaluations that process payrollresults.

Procedure
If you do not use Swiss Payroll or do not run Swiss Payrollin client &V1&, you can ignore this message and all other errormessages associated with the program.
Otherwise, you must remove the cause of the error and restart theconversion before your first live payroll or evaluation as follows:
If the situation described in the Diagnosis section (more than oneentry of this wage type with 01.01.1998 <= ENDDA < 01.01.2002) doesnot apply, the problem is probably caused by a program error.Please contact SAP Support.
Otherwise, you must remove superfluous entries with an end date in therange of 01.01.1998 - 12.31.2001 until no more than one such entryexists. If you are not sure which entries are superfluous, copy thiswage type's entry (with time interval 01.01.1801-12.31.1801) to thetime interval 01.01.1998-12.31.2001. Before copying, you may need todelete any entries with ENDDA='12.31.2001'. After you have checked thedate of subapplication SV01 (table T596D), you must use programRPU40AC0 to restart the conversion; this applies toboth cases described above.

Procedure for System Administration
If you use Swiss Payroll, inform the HR administrator who isresponsible. For more details on the conversion, see note 426423 andthe documentation on reportRPU40BX_CH_SVLGARTS.